Beam end covers

From GTM Workshop

Build Manual Build Sequence Monocoque Front End Rear End Doors Finishing Donor Components Rover Metro Donor Components Rover 220/420 Components Build Sections Battery Beam end covers Bonnet and front spliter mould Boot bootlock and hinges Brake lines Carpets Dashboard cover Doors Engine cover moulding Engine frame Engine and auxiliaries Exhaust Front suspension Gear change Handbrake lever cables and calipers Door panels Trim Headlight covers Heater and pipework Lights Part trim panels option Pedal box and master cylinder Perspex screens rear and side Petrol tank filler neck and cap Pipes and services through the tunnel Radiator ducting and splash moulds to monocoque Radiator mould radiator and pipework Rear suspension Roof panel Seat belts Seats and runners Separate instrument option Setting up the car for the road Soft trimming Spare wheel mould and spare wheel Steering rack and column Throttle pedal Trimming hard panels Windscreen and rear bulkhead screen Windscreen washer bottle pipes and jets Wiper motor and blades Wiring Wiring loom insruments and fuse box 1800 gear change p.g.1 gearbox 1800 engine mountings 5AS alarm units Hydraulic clutch 1800 engine steady Spyder Supplement Top Seatbelt Mounting Hood Boot Engine Compartment Grills Stainless Steel Mesh

Beam end covers are used at the rear of the sills to cover the mountings for the rearward facing wishbones. These covers are non structural.

Assembly

Drill two clearance holes 7mm in diameter through the two ends of the rebated face Of the beam end covers. Place the covers onto the ends of the sills and mark the position of the holes previously drilled. Drill out these Darks with a tapping side drill for the self tapping screw. Attach the covers with two self tapping screws.