GTM Libra Rover Metro Donor Components

From GTM Workshop

Build Manual Build Sequence Monocoque Front End Rear End Doors Finishing Donor Components Rover Metro Donor Components Rover 220/420 Components Build Sections Battery Beam end covers Bonnet and front spliter mould Boot bootlock and hinges Brake lines Carpets Dashboard cover Doors Engine cover moulding Engine frame Engine and auxiliaries Exhaust Front suspension Gear change Handbrake lever cables and calipers Door panels Trim Headlight covers Heater and pipework Lights Part trim panels option Pedal box and master cylinder Perspex screens rear and side Petrol tank filler neck and cap Pipes and services through the tunnel Radiator ducting and splash moulds to monocoque Radiator mould radiator and pipework Rear suspension Roof panel Seat belts Seats and runners Separate instrument option Setting up the car for the road Soft trimming Spare wheel mould and spare wheel Steering rack and column Throttle pedal Trimming hard panels Windscreen and rear bulkhead screen Windscreen washer bottle pipes and jets Wiper motor and blades Wiring Wiring loom insruments and fuse box 1800 gear change p.g.1 gearbox 1800 engine mountings 5AS alarm units Hydraulic clutch 1800 engine steady Spyder Supplement Top Seatbelt Mounting Hood Boot Engine Compartment Grills Stainless Steel Mesh

1. Engine and Gearbox, complete with all ancillaries i.e.
   • Original ECU sensors and engine bay wiring loom.
   • All engine bay water hoses, pipes and water rails.
   • Starter motor, alternator, coil & mtg. bracket, relay unit & mtg. standard engine mountings.
   • Standard GTI tubular exhaust manifold.
2. Parts required for the Libra front suspension.
   • Two front hub assemblies complete with top ball joint, brakes, gallopers, brake pads and outer part of drive shaft assembly including nuts.
   • Steering arms and mounting sleeves.
3. Parts required for the Libra rear suspension.
   • Two front hub assemblies (solid discs) complete with top ball joint & bottom swivels (not G.T.I.)
   • On both the front and rear hub assemblies the disc brake backing plates are not used on the GTM.
4. Metro drive shafts one pair (including end nuts)
5. Expansion tank, mountings, rubber pipes and all fittings.
6. Wiring loom complete.
7. Petrol Tank, fuel pump and all pipes and filters. Including petrol neck and pipes.
8. Main fuel filter, mounting bracket, pipes and unions.
9. Gear linkage complete, gear lever, knob, gaiter & mtg. bracket.
10. Radiator & Fan. Mounting grommets, all hoses pipes & fittings.
11. Heater Blower unit, complete with rubber seal and fixings.
12. Heater Unit, complete with all hoses and fixings.
13. Heater controls, complete with control cables, clips & fixings.
14. Dashboard mould with instruments, switches, and all ancillaries.
15. Dashboard wiring loom including main fuse box.
16. Steering coulomb including universal joint & steering wheel.
17. Steering coulomb switchgear complete with plastic binnacle wiring, fixings steering lock and key
18. Pedal box, pedals, master cylinder, servo & pipe, brake switch.
19. Throttle pedal. Mounting bracket & throttle pedal switch.
20. Door Weather seal.
21. Wiper motor, motor linkage, wiper arms, spindles & fixings.
22. Washer bottle, pipes jets & fixings.
23. Fuse link box, top, clip mounting bracket & fixings.
24. Dim dip unit.
25. Horn & mounting bracket.
26. L.H.D. Steering rack with standard track rod ends (not G.T.I.)
27. Window regulators (LH. & RH. doors) 28. Side window glass, regulator channels & rubber fixing strip.
28. Door latch mechanisms, lock rods & strikers. (LH. & RH. doors)
29. Inner door, window - winders, plastic covers & fixings.
30. Door locks & keys (LH. & RH. doors). One extra lock and key (Boot Lock)
31. Wing mirrors (LH & RH doors)
32. Battery.
33. Rear View mirror.
34. Seat Belts complete set including inertia reels.
35. Seats. Driver & passenger, including runners.