Windscreen and rear bulkhead screen

From GTM Workshop

Build Manual Build Sequence Monocoque Front End Rear End Doors Finishing Donor Components Rover Metro Donor Components Rover 220/420 Components Build Sections Battery Beam end covers Bonnet and front spliter mould Boot bootlock and hinges Brake lines Carpets Dashboard cover Doors Engine cover moulding Engine frame Engine and auxiliaries Exhaust Front suspension Gear change Handbrake lever cables and calipers Door panels Trim Headlight covers Heater and pipework Lights Part trim panels option Pedal box and master cylinder Perspex screens rear and side Petrol tank filler neck and cap Pipes and services through the tunnel Radiator ducting and splash moulds to monocoque Radiator mould radiator and pipework Rear suspension Roof panel Seat belts Seats and runners Separate instrument option Setting up the car for the road Soft trimming Spare wheel mould and spare wheel Steering rack and column Throttle pedal Trimming hard panels Windscreen and rear bulkhead screen Windscreen washer bottle pipes and jets Wiper motor and blades Wiring Wiring loom insruments and fuse box 1800 gear change p.g.1 gearbox 1800 engine mountings 5AS alarm units Hydraulic clutch 1800 engine steady Spyder Supplement Top Seatbelt Mounting Hood Boot Engine Compartment Grills Stainless Steel Mesh

The windscreen and rear bulkhead screen, on the Libra, are both bonded to the tub using conventional bonding agents. The front screen is laminated and tinted and the rear screen is toughened glass Wind-screen and rear bulkhead screen assembly.

Although we have fitted a number of windscreens and rear bulkhead screens ourselves it is strongly recommended that the fitting of the two screens should be undertaken by a professional windscreen fitter (Yellow Pages).

Using a professional windscreen fitter has, a number of advantages.

• They will guarantee a fit without leakage.
• They will be able to offer a number of rubber trim panels to go around the outside edge of the glass which in turn will make a much neater job.
• They will be able to supply the black primer paint which is required for the inside edge of the screens to obscure the glue when they bond them in