Windscreen washer bottle pipes and jets

From GTM Workshop

Build Manual Build Sequence Monocoque Front End Rear End Doors Finishing Donor Components Rover Metro Donor Components Rover 220/420 Components Build Sections Battery Beam end covers Bonnet and front spliter mould Boot bootlock and hinges Brake lines Carpets Dashboard cover Doors Engine cover moulding Engine frame Engine and auxiliaries Exhaust Front suspension Gear change Handbrake lever cables and calipers Door panels Trim Headlight covers Heater and pipework Lights Part trim panels option Pedal box and master cylinder Perspex screens rear and side Petrol tank filler neck and cap Pipes and services through the tunnel Radiator ducting and splash moulds to monocoque Radiator mould radiator and pipework Rear suspension Roof panel Seat belts Seats and runners Separate instrument option Setting up the car for the road Soft trimming Spare wheel mould and spare wheel Steering rack and column Throttle pedal Trimming hard panels Windscreen and rear bulkhead screen Windscreen washer bottle pipes and jets Wiper motor and blades Wiring Wiring loom insruments and fuse box 1800 gear change p.g.1 gearbox 1800 engine mountings 5AS alarm units Hydraulic clutch 1800 engine steady Spyder Supplement Top Seatbelt Mounting Hood Boot Engine Compartment Grills Stainless Steel Mesh

The Libra utilises the standard Rover Metro wiper bottle, pipes and jets. The bottle is mounted on pre-moulded suppers in the radiator ducting and the pipes run from the bottle through the front bulkhead of the monocoque to moulded positions for the two jets.

Assembly

The standard K Series Rover screen washer bottle is secured to the top of the radiator ducting with three number eight self tapping screws 12mm long. The screen jet tube runs under the water bottle through the same grommet as the speeds cable and across the dashboard to the two K Series Rover Metro screen jets.

These jets fit into the bodywork on the two raised sections either side the central mounting position for the bonnet. The standard K Series T pieces used between the two jets and then down to the water bottle. It is necessary to block of the rear screen wash washer pipe to the small piece of piping and suitable bung.